Overview
The Quikscribe Hand
Control
operates Quikscribe Recorder. If the Quikscribe Hand Control is
not plugged in and configured correctly, Quikscribe will only work
in DEMO mode. This means you will only be able to record audio files
up to 30 seconds in duration.
To install
the Quikscribe Hand Control, do the following.
1. Plug the
DB9 connector on the Hand Control into the serial port on your
PC.
2. Plug the
3.5mm Microphone Plug (which loops out of the DB9 connector) into
the Microphone Line input of your sound card in PC.
3. Start the
Quikscribe Recorder.
Note: By default
the Quikscribe Recorder is set up to auto-detect the Hand Control.
If for some reason you wish to change the Comm Port setting for
the Quikscribe Hand Control, you can do so by clicking on the
Record Tab under the Settings Icon and then change the "Hand
Control - Comm Port" setting from Auto-detect to either Comm
1 or Comm 2. If you ever change this setting, you will need to
close Quikscribe down and re-open it again in order for these
changes to take effect, as Quikscribe needs to reinitialise the
Comm Port.
|
